Originals · Startup · Startups & Fintech
Agnikul test-fires a pump-driven Agnilet engine, now with 3D-printed electric pumps, ahead of Mission-02
The engine that flew pressure-fed on Agnibaan SOrTeD in 2024 now draws its propellant through electric motor-driven pumps, and the Chennai startup showed it throttling up and down.

Agnikul Cosmos, the Chennai launch startup founded at IIT Madras in 2017, released footage on 18 November 2026 of a test firing of an electric motor-driven version of its Agnilet semi-cryogenic engine, as it prepares for Mission-02 of its Agnibaan rocket, India Today and NewsBytes reported. The video shows the engine being run at different power levels, with operators gradually raising and then lowering its thrust. As the thrust rises, Mach diamonds, the bright diamond-shaped patterns formed by shock waves in high-speed exhaust, appear in the plume, and they fade again as the engine throttles down.
The change is in how the propellant reaches the engine. Agnilet already flew as a pressure-fed engine on Agnibaan SOrTeD, the company's first suborbital flight in May 2024, where high-pressure gas pushes fuel and oxidiser out of the tanks. The new version uses electric motor-driven pumps, which India Today noted can allow lighter tanks and more control over how much propellant reaches the engine. In its own post, quoted by India Today, Agnikul said the engine is still a single piece, still fully 3D printed and still semi-cryogenic, and now has 3D-printed pumps too. It burns liquid oxygen and a kerosene-based fuel.
The firing was done on a horizontal stand. Agnikul said the test brings its older horizontal semi-cryogenic engine test facility back into use, so that engine testing and flight qualification work can run in parallel, India Today reported. NewsBytes added that the horizontal stand gives engineers a clearer view of the plume while they study how the engine behaves at different thrust levels. Neither report gives a burn duration or measured thrust for this test, and the footage is company-released.
Throttling matters for where Agnikul wants to go next. In September the Technology Development Board under the Department of Science and Technology signed an agreement to give the company Rs 200 crore from the Research Development and Innovation Fund, through optionally convertible debentures, to develop a fully reusable Agnibaan, the Press Information Bureau said. That design calls for a semi-cryogenic propulsion system capable of deep throttling and restart, which PIB described as critical for descent and landing. NewsBytes reported that Mission-02 is meant to take Agnikul closer to an orbital launch and to demonstrate technologies for recovering and reusing rocket hardware.